Znaleziono w kategoriach:
Golarka REMINGTON XF8500 Smart Edge

Instrukcja obsługi Golarka REMINGTON XF8500 Smart Edge

Wróć
XF8500
XF8700
Smart Edge / Smart Edge Pro
2
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
F IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY
TO PERSONS:
1 This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they
are older than 8 and supervised. Keep the appliance and cable out of reach
of children under 8 years.
2 Do not leave the appliance unattended while plugged in.
3 Keep the power plug and cord away from heated surfaces.
4 Make sure the power plug and cord do not get wet.
5 Do not plug or unplug the appliance with wet hands.
6 Do not use the product with a damaged cord. A replacement can be
obtained via our International Service Centres.
7 Do not twist or kink the cable, or wrap it round the appliance.
8 Store the product at a temperature between 15°C and 35°C.
9 Suitable for cleaning under an open water tap.
10 Suitable for use in a bath or shower.
11 Do not submerge the appliance.
12 This appliance is not intended for commercial or salon use.
ENGLISH
3
C KEY FEATURES
1 On/o switch 8 Pop-up trimmer (on back)
2 Pre-trim cutters 9 Head guard (not shown)
3 Shaving foil 10
Foil assembly release buttons
4 Hair pocket
11
Charging stand (not shown)
5 3 stage charge indicator (XF8500) 12 Adaptor (not shown)
6 LED display (XF8700) 13 Storage pouch (not shown)
7 Charging pins
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA
5
10 4
8
6
7
32
1
4
C GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to
allow time for your beard and skin to become accustomed to the new shaving
system.
, CHARGING YOUR SHAVER
Ensure the product is switched o.
• Connecttheadaptortothechargestandandthentothemains.
• Placethechargestandonaatsurface.
• Placetheshaverinthechargestandwiththechargepinscontacting.
• Chargeforatleast24hourswhenusingforthersttime.
• XF8500:AtLowChargetheLEDindicatorwillashrapidly.WhenCharging
theLEDwillashslowly.WhenfullychargedtheLEDwillstayonsolid.
• XF8700:Whenchargeislow‘Lo’willashrapidlyonthescreen.When
charging,theLEDsashinaclockwiserotation.Whenfullychargedthe
minuteswillpulse‘60’minutes.
• Topreservethelifeofyourbatteries,letthemrunoutevery6monthsthen
recharge for 24 hours.
• Theadaptorautomaticallyadjuststoamainsvoltagebetween100Vand
240V.
• Thisapplianceshouldbechargedbyapprovedsafetyisolatingadaptors
PA-0510E(K)withtheoutputcapacityof5.0Vdc;1.0A.
• Quickchargefeature:Yourshaveristtedwitha5minutequickcharge
feature that will provide enough charge for 1 shave (3 minutes).
F INSTRUCTIONS FOR USE
, SHAVING
1 Make sure your shaver is properly charged.
2 Switch the shaver on by pressing the on/o switch.
3 Stretch the skin with your free hand so the hairs stand upright.
4 Hold the shaving head so that the foils touch your face.
5 Use short, linear strokes.
, TRIMMING
6 Switch the shaver on.
7 Push the trimmer release button up to activate the trimmer.
8 Hold the trimmer at a right angle to your skin.
9 To retract the trimmer, slide the trimmer release button down and push the
back of the trimmer head downwards until it locks into place.
ENGLISH
5
E Tips for best results
Always hold the shaver at right angles to the skin so that all three foils are
touchingtheskinwithequalpressure.
Use moderate to slow stroking movements. The use of short linear motions
in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
, DO NOT press hard against the skin in order to avoid irritation and damage
to the foil heads.
, Note: your shaver has been designed to be used in the shower if
desired.
C CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance.
We recommend you clean your product after each use.
The easiest and most hygienic way to clean the appliance is by rinsing the
appliance head after use with warm water.
Keep the switch in the “o” position when not in use.
, CLEANING CAUTIONS
Ensure the shaver is switched o and unplugged from the power source.
Remove the foil assembly by pressing the release buttons on either side of
the head and lifting the foil assembly upwards to remove from the hair
pocket.
Tap out the excess hair shavings and rinse the foils under running water.
Do not clean the shaving foil with a brush.
Replace the head assembly by placing the assembly on top of the hair
pocket, press down and click into place.
, CLEANING TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing
machine oil.
, REPLACING THE FOILS & CUTTERS
Toensurecontinuedhighqualityperformancefromyourshaver,we
recommend the foils and cutters are replaced every six months.
, Signs that your foils and cutters need replacing.
Irritation: as foils get worn, you may experience excessive skin irritation.
Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
Wear through: you may notice that the cutters have worn through the foils.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA

Właściciel serwisu: TERG S.A. Ul. Za Dworcem 1D, 77-400 Złotów; Spółka wpisana do Krajowego Rejestru Sądowego w Sądzie Rejonowym w Poznań-Nowe Miasto i Wilda w Poznaniu, IX Wydział Gospodarczy Krajowego Rejestru Sądowego pod nr KRS 0000427063, Kapitał zakładowy: 41 287 500,00 zł; NIP 767-10-04-218, REGON 570217011; numer rejestrowy BDO: 000135672. Sprzedaż dla firm (B2B): dlabiznesu@me.pl INFOLINIA: 756 756 756